PHILIPS CONSUMER ELECTRONICS, CO. PCA28EM (EUROPEAN) Card Type Modem Chip Set Unidentified I/O Options Line in, 25-pin DTE port, power Maximum Modem Rate 115.2Kbps Maximum Fax Rate 14.4Kbps Data Modulation Protocol Bell 103/212A ITU-T V.22, V.22bis, V.32, V.32bis, V.34, V.FC Fax Modulation Protocol ITU-T V.17, V.27ter, V.29 Error Correction/Compression MNP5, V.42, V.42bis Fax Class Class I & II Data Bus External [Image] CONNECTIONS Function Label Function Label Line in (RJ-11) CN1 Power CN3 25-pin DTE port CN2 Power switch SW1 DIAGNOSTIC LED(S) LED Color Status Condition MR Unidentified On Power is on MR Unidentified Off Power is off TR Unidentified On DTR signal is high TR Unidentified Off DTR signal is low SD Unidentified On Modem is transmitting data SD Unidentified Off Modem is not transmitting data RD Unidentified On Modem is receiving data RD Unidentified Off Modem is not receiving data OH Unidentified On Modem is off hook OH Unidentified Off Modem is on hook CD Unidentified On Carrier signal detected or error correction negotiation completed CD Unidentified Off Carrier signal not detected AA Unidentified On Auto-answer enabled AA Unidentified Off Auto-answer disabled AA Unidentified Blinking Incoming ring detected HS Unidentified On Mdem is connected at 28.8Kbps HS Unidentified Off Modem is not connected or connected at speed lower than 28.8Kbps TST Unidentified On Normal operation; no error detected TST Unidentified Off Error detected and corrected SUPPORTED COMMAND SET Basic AT Commands AT, ‘+++’, A/ A, E, H, M, P, T, V, X, Y, Z &C, &G, &M, &R, &T, &V, &W, &X, &Z Extended AT Commands %A, %C \A, \B, \C, \E, \G, \J, \K, \O, \Q, \T, \U, \X, \Y, \Z S Registers S0, S1, S2, S3, S4, S5, S6, S7, S8, S9,S10, S11, S12, S14, S18, S25, S26 Note: See MHI Help File for full command documentation. PROPRIETARY AT COMMAND SET For a full command summary see, PHILIPS CONSUMER ELECTRONICS, CO. PCA28EM (USA)